Motorola GP68 - Manual (Page 30)

30
Model ST-865M3 SmarTrunk II™ Logic Board
3.5 Portable Radio Programming
Program the radio for the SmarTrunk II operating frequencies and the
various radio operating parameters required. Refer to the GP68 instruction
manual for specific instructions. When the radio programming is complete,
the SmarTrunk II Logic Board can be programmed by following the
procedure described in Section 4.
The most effective method to evaluate proper programming of a radio
involves system use. It is recommended that the System Operator/Manager
set up at least two specific Subscriber ID Numbers and associated Paging
Codes for each designated installer for test purposes. This provides a
basis for progamming all radios prior to specific subscriber activation. It
also provides an evaluation capability for installers. One set of numbers
should be an individual (half duplex type) the other group (group type).
3.5.1 System Tone
All subscribers on a SmarTrunk II system MUST be pro-
grammed with the same system tone that is programmed in
the ST-852M controller. The System Operator/Manager
determines the System Tone Frequency. This parameter is
set as a radio function with the Motorola RX PL SQUELCH
code.