MITSUBISHI ELECTRIC DIAMOND PRO 900U NFJ9905SKHUW - Manual (Page 30)

- 1-29 -
ENGLISH
USB UP-STREAM
Press the Minus Button: Press the Plus Button:
USB PORT
COMBINATION
Group
Icon
Item
Icon
Item
The USB functions of the
computer connected to
Upstream port ROOT-A
become active. The USB functions of the
computer connected to
Upstream port ROOT-B
become active.
The Upstream port in active is colored by blue on the
OSD screen.
In case that either the Upstream port ROOT-A or
ROOT-B is chosen by this function, the auto-change
of the Upstream port is not available.
It may take about 15 seconds until the USB devices
have been recognized by the computer after the
Upstream port is changed.
The Upstream port ROOT-
A is assigned for signal
input connector "D-SUB"
and ROOT-B is assigned
for "BNC" The Upstream port ROOT-
A is assigned for signal
input connector "BNC" and
ROOT-B is assigned for "D-
SUB".
This function is to change the Upstream port auto-
matically in corresponding to the change of signal
input connector.
This function is only available in case that both the
Upstream ports are connected to the computers.
It may takes 15 seconds until the USB devices have
been recognized by the computer after the Upstream
port is changed.
In case that the computer chosen enters into a power
management mode, the signal input connector and
Upstream port are changed to others automatically.
When the Upstream port which is connected to the
computer not displays on the screen is selected, the
operation of the USB devices connected to the
Downstream ports is not shown on the screen of the
display monitor.
N O T E
N O T E