beautypg.com

Introduction, Scanning sequence examples, Errors while scanning – Motorola SYMBOL LS9203 User Manual

Page 185

background image

Symbologies

9-5

Introduction

This chapter describes all symbology features and provides the programming bar codes necessary for selecting these features for the
Symbol LS9203 scanner. Before programming, follow the instructions in

Chapter 1, Getting Started

.

The scanner is shipped with the settings shown in the

Symbology Default Table on page 9-6

(also see

Chapter A, Standard Default

Parameters

for all host device and miscellaneous scanner defaults). If the default values suit your requirements, programming may

not be necessary. Features values are set by scanning single bar codes or short bar code sequences.

To return all features to their default values, scan the

Set All Defaults

bar code on

page 4-5

.

If using a USB cable, select a host type. Refer to each host chapter for specific host information.

Scanning Sequence Examples

In most cases only scan one bar code to set a specific parameter value. For example, to transmit bar code data without the UPC-A
check digit, simply scan the

Do Not Transmit UPC-A Check Digit

bar code listed under

Transmit UPC-A/UPC-E/UPC-E1 Check Digit on

page 9-25

. The scanner issues a short high beep and the LED turns green, signifying a successful parameter entry.

Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes in the proper sequence. Refer to the
individual parameter, like Set Length(s) for D 2 of 5, for this procedure.

Errors While Scanning

Unless otherwise specified, if an error is made during a scanning sequence, just re-scan the correct parameter.