MITSUBISHI ELECTRIC LT-2220 - Manual (Page 28)

28
If the slide switch is set to TV when you enter an A/V
receiver code, VOLUME and MUTE will control
the A/V receiver rather than the TV. To return
volume and mute control to the TV, set the slide
switch to TV, press and hold POWER and enter 000.
Some manufacturers may change their products, or
they may use more than one remote control system.
If this is the case, your remote control may not be
able to operate your VCR, DVD, cable box, satellite
receiver, or A/V receiver.
Figure 5. Programming the remote to control your
A/V receiver.
Use of the Remote Control with Other A/V Products
After entering the correct codes in each position of the
remote control, use the slide switch to select which
product will respond when an operational button is
pressed. If you enter a code from the AUDIO chart
while the slide switch is set to TV, the volume and
mute functions change to match the A/V receiver.
This is useful when using an A/V receiver with the
TV all the time. In all other cases, only one of the
below devices is allowed for each slide switch position.
TV position:
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
VCR position:
VCR
DVD position:
DVD
LD Player
Audio position:
A/V receiver
Mitsubishi CD player
If you have a Mitsubishi A/V receiver, the audio position
may be used in conjunction with select Mitsubishi CD
players. Your audio position must be programmed to
either 010 or 011. Plug the CD player power cord into a
switched outlet on the back of your A/V receiver. Pressing
the POWER button turns On the A/V receiver, along
with the CD player. In the audio position, for some
CD players, the transport controls (FF, Play, Rew, etc.)
operate the CD player.
Figure 4. Programming the remote to control your
DVD or LDP.
POWER
Code to enter:
To reset to default code, enter 000
DVD/LDP brand
Mitsubishi
JVC
Panasonic
Philips
Pioneer DVD
Samsung
Sony
Toshiba
003
257
250
258, 253, 272
252
261
254
253
If your
DVD
code is not
listed here,
please see
page 59
for a
complete
listing.
DVD Player Codes
1. 2.
3.
TV AUDIO
CABLE/DBS/DTV DVD VCR
POWER
Code to enter:
To reset to default code, enter 000
Audio brand
Mitsubishi A/V receiver
and/or CD player
Denon
Harman Kardon
JVC
Kenwood
Marantz
Onkyo
Pioneer
Sony
Technics
Yamaha
010, 015, 011, 012,
013, 014
234, 235, 236, 245,
246, 359
215, 223, 242
233, 232
208, 200
224, 350
209, 214, 240, 247
205, 207
222, 249
218, 219, 221
202, 201, 243, 244
If your
audio
code is not
listed here,
please see
page 59
for a
complete
listing.
A/V Receiver Codes
1.
3.
2.
TV AUDIO
CABLE/DBS/DTV DVD VCR