Miller Electric MR-5 - Manual (Page 22)

2. Removescrews securing board to stand-offs. Do
not remove stand-offs.
3. Disconnect plugs PLG2O and PLG24 from mat-
ching receptacles on PC4.
4. Gently pull board straight away from front panel.
Do not pull up or down; otherwise, the meters
and LED’s may be damaged.
5. To replace meter(s) proceed as follows:
a. Remove nuts and lock washers from meter
support.
b. Gently pull meter straight out of socket. Re-
tain spacers.
Figure 5
-
2. Circuit Board Replacement
Digital Motor
Speed
Receptacle RCS
Interface
Receptacle RC1 9
Receptacle R(
Voltage
Circuit Board PCi
Circuit
Receptacles RC2O And RC24
RF Filter Circuit
Board PCS
Receptacles R021 And RC22
Ret TO-i 14 344
OM-882 Page 9