Magellan GPS 320 - Manual (Page 49)

Magellan GPS 315/GPS 320 41
Customizing
Selecting Setup
Setup allows you to initialize the receiver and set system
parameters to your preference.
MENU
COORD SYS
MAP DATUM
ELEV MODE
PROJECTION
TRIP RESET
WAYPOINTS
ROUTES
SETUP
SUN/MOON
FISH/HUNT
CONTRAST
ALARM/MSG
From any
NAV screen
MENU
Select
SETUP
ENTER
FIG .
E
Selecting Initialize
By initializing your receiver, you establish the initial position
for the receiver. This will enable the receiver to search the
sky for available satellites. You will need to reinitialize if you
have traveled more than 300 miles while the receiver is
turned off. To initialize:
Follow the steps requested to initialize, as done when the
receiver was initialized the first time (see Getting Started).
Disabling NAV Screens
You may find that you do not use one, or more, of the nine
NAV screens provided in the receiver. You have the option
to disable NAV screens, except for the STATUS and
POSITION screens.
The default for
the TIME screen
is off.
MENU
Select
SETUP
ENTER
Select
INITIALIZE
ENTER
FIG .
F
Figure E. Refer to
this screen
anytime you want
to access Setup.
SETUP
INITIALIZE
NAV SCREENS
COORD SYSTEM
MAP DATUM
ELEV MODE
TIME FORMAT
NAV UNITS
NORTH REF
LIGHT TIMER
BEEPER
PERSONALIZE
CLEAR MEMORY
NMEA
BAUD RATE
SIMULATE
Figure F. If you
need to initialize
again, make this
selection.