Motorola 9500 - Manual (Page 64)

60 Using In-Call Features
Placing a Call on Hold
You must subscribe to this network feature through
your service provider(s).
Note: This feature behaves differently based on the
mode you are in. Check your mode settings before
using this feature. See “Selecting a Mode” on
page 169.
Satellite
Mode You can place a call on hold to receive a new call or
while making a new call. You can only place one
call on hold at a time, so some options may not be
accessible if you have already placed a call on
hold.
To place a call on hold:
1. Press
M
until you will see Call Hold .
2. Press
O
. Your current call is put on hold and
you will see Call Holding followed by
Reconnect? .
Once you a call is on hold, you have these options:
If you want to... Then...
Make a new call
1. Press
M
until you will see
Make New Call , and then
press
O
to select.
2. Dial the number as usual, and
then press
O
to place the
call.
Switch Between
Calls
When you are connected to either
number, you will see
2 Calls
followed by Switch? .
Press
O
to switch to the other call
and automatically place the current
call on hold.
End Both Calls
Close the flip cover.
or
Press
M
until you will see End
Current & Held Call , and
then press
O
to select.
Both calls are disconnected, and
the display returns to standby.