Miller Electric DS-64M Swingarc - Manual (Page 36)

OM-1588 Page 32
SECTION 12 − SETTING SharpArcE CONTROL
12-1. Selecting And Adjusting SharpArcE Control
Ref. S-0259
1 Arc
SharpArc ™ is “Arc” on the display.
It is used to adjust arc cone width
and arc characteristics.
Use front panel parameter select
button to move > to select Arc. Use
Display Control to adjust Arc
setting.
SharpArc
™ setting range is from 0
to 20. The factory default is set at
zero (0). When Arc value is
increased toward 20, the arc cone
narrows and the weld puddle
becomes less fluid.
5 0 T r i m
2 0 0 I P M
> P r g 1
0 3 5 “ S t
5 0 T r i m
2 0 0 I P M
P r g 1
> A r c 0
1
Parameter
Select
5 0 T r i m
2 0 0 I P M
P r g 1
> A r c 2 0