MITSUBISHI ELECTRIC FC810 User Manual
Page 15
MITSUBISHI ELECTRIC MOTHERBOARD DIVISION
PAGE 15 OF 45
!
Do not use excessive force. If the module will not fit easily, remove it and start again.
The DIMM is inserted vertically and held in place by the clips at each end.
" !
Do not use excessive force. If the module will not come free easily, check that the holding clips
are clear of the module ends.
Press the tabs on both of the socket’s end clips at the same time. This releases the DIMM and
lifts it partly out of the socket.
. / 0)
1.
Turn off the computer and unplug all power cords. Take suitable anti-static precautions and
remove the system cover.
2.
If the system was in use just before starting this procedure, the processor may be hot, wait
until it cools
3.
Unclip the heatsink/ fan from the processor and lift the clip on the side of the processor
socket.
4.
The processor can now be removed from the socket.
Caution
Handle the processor with care, by the body only. Avoid touching the connector at the
bottom. Store in an antistatic container.