Motorola E398 GSM - Manual (Page 30)

30 April 21, 2004 6809480A37-O
Disassembly E398/E399 GSM
Removing and Replacing the Camera From MFT Chamber Assembly
1. Remove the battery cover, battery, rear housing, and transceiver PC board as
described in the procedures.
2. Disengage the two plastic MFT Chamber assembly side connectors from the
transceiver PC board and lift up the MFT Chamber assembly.
3. Using the disassembly tool, gently pry up the camera flex connector from the
transceiver PC board.
4. Using plastic tweezers, gently pry the connection between the camera flex and
the MFT Chamber assembly separating the adhesive.
5. To replace, press the MFT Chamber side of the camera flex connector onto the
MFT Chamber assembly.
6. Place the camera flex connector on the transceiver PC board camera connector
and press it into place.
7. Fold over the MFT Chamber assembly, aligning the camera with the camera
hole in the MFT Chamber and press into place engaging the two plastic side
connectors on to the transceiver PC board.
8. Replace the transceiver PC board, rear housing, battery, and battery cover as
described in the procedures.
Figure 16. Removing and Replacing the Camera From the MFT Chamber
Assembly
Disassembly Tool MFT Chamber
ssembly T Camera
Disassembly Tool Plastic Tweezers
sassembly Too Camera Flex