Manitowoc Ice Q 800 - Manual (Page 10)

Installation Instructions Section 2
2-4
Water Service/Drains
Water Inlet Lines
Follow these guidelines to install water inlet lines:
• Do not connect the ice machine to a hot water
supply. Be sure all hot water restrictors installed
for other equipment are working. (Check valves
on sink faucets, dishwashers, etc.)
• If water pressure exceeds the maximum
recommended pressure, obtain a water pressure
regulator from your Manitowoc distributor.
• Install a water shut-off valve for both the ice
making and condenser water lines.
• Insulate water inlet lines to prevent condensation.
• Use teflon tape to seal threaded fittings.
Important
Install sump trough drain plug before starting the
ice machine.
Drain Connections
Follow these guidelines when installing drain lines to
prevent drain water from flowing back into the ice
machine and storage bin:
• Drain lines must have a 1.5 inch drop per 5 feet
of run (2.5 cm per meter), and must not create
traps.
• The floor drain must be large enough to
accommodate drainage from all drains.
• Run separate bin and ice machine drain lines.
Insulate them to prevent condensation.
• Vent the bin and ice machine drain to the
atmosphere. Do not vent the condenser drain on
water-cooled models.
CAUTION
Plumbing must conform to applicable
codes.
WATER SUPPLY AND DRAIN LINE SIZING/CONNECTIONS
Location
Water
Temperature
Water
Pressure
Ice Machine
Fitting
Tubing Size Up to Ice
Machine Fitting
Ice Making
Water Inlet
33°F (0.6°C) Min.
90°F (32.2°C)
Max.
20 psi (137.9 kPA) Min.
80 psi (551.5 kPA) Max.
3/8” Female
Pipe Thread
3/8” (9.5 mm)
minimum inside
diameter
Ice Making
Water Drain
--- ---
1/2” Female
Pipe Thread
1/2” (12.7 mm)
minimum inside
diameter
Condenser
Water Inlet
33°F (0.6°C) Min.
90°F (32.2°C)
Max.
20 psi (137.9 kPA) Min.
150 psi (1034.2 kPA)
Max.
3/8” Female Pipe Thread
Condenser
Water Drain
--- ---
1/2” Female
Pipe Thread
1/2” (12.7 mm)
minimum inside
diameter
Bin Drain --- ---
3/4” Female
Pipe Thread
3/4” (19.1 mm)
minimum inside
diameter