Determining the remote control id – Motorola RG2200 User Manual
Page 38
38
D
ETERMINING
THE
R
EMOTE
C
ONTROL
ID
Depending upon the model of the remote control, instructions are as follows.
Following are the sequences of flashing that indicate how your remote control ID is programmed.
•
A short burst of flickering indicates a 0 (zero). A number of longer, steady blinks indicates a non-zero digit, such as
the following.
•
•
After blinking, the remote returns to normal operation.
SRC-300
SRC-200
1.
Press the LED key for 3 seconds until the LED flashes.
2.
Press the INFO key. The LED stops blinking at this point
and stays on solid.
3.
Press the A key and watch the LED.
1.
Press the A button and hold it down until the LED at the
top of the remote flashes rapidly.
2.
Press the FAV button and watch the LED.
Number of flashes
Remote Control ID
Mode
Rapid flickering
For TV1, which is in the same room as your RG2200
IR (Infra Red)
1
Remote TV1: Primary TV is in a different room than the RG2200.
UHF (ultra high frequency)
2
Remote TV2.
UHF
3
Remote TV3 (3-stream models only)
UHF