Multi-Tech Systems MULTIVOIP MVP-2410 - Manual (Page 552)

Call States/Reasons MultiVOIP User Guide
552
Call Reasons sent to Embedded Gatekeeper Software
with respect to a Call State.
No State Description
1 Undefined No reason.
2 Resource Unavailable The call was rejected because of a lack of
Gatekeeper resources.
3 Invalid Endpoint The ARQ/DRQ was rejected because no
valid endpoint was identified.
4 Route Call To GK The destination ARQ was rejected because
no Setup message preceded it.
5 Lines Busy The call cannot be completed because Line
Hunting failed.
6 Destination Out Of
Service The call cannot be completed because the
destination cannot be reached.
7 Destination Busy The call cannot be completed because
destination is busy.
8 No Answer at
Destination The call cannot be completed because the
user at the destination did not answer in the
given time.
9 Destination Rejected
the Call The call cannot be completed because the
party at the destination rejected the call.
10 Origin Disconnected A connected call was disconnected because
of the origin. The reason for state
Disconnected.
11 Destination
Disconnected A connected call was disconnected because
of the destination. The reason for state
Disconnected.
12 New Admission from
Origin The reason for address resolution because
of a new admission.
13 New Setup from
Origin The reason for address resolution because
of a new Setup.
14 Origin Setup The reason for wait offering when the Setup
is not the first message in call. (An ARQ
was received.)
15 Destination Info In
LRQ An LCF arrived with no CallSignal Address
but with a new destinationInfo alias. The
Gatekeeper sent an Address Resolution state
with this reason in order to translate the new
found alias to a valid IP address.