Wiring requirements, Connecting the power, Grounding nport ia5150/5250 series – Moxa Technologies IA5150 User Manual
Page 11: Wiring requirements -3, Connecting the power -3, Grounding nport ia5150/5250 series -3
NPort IA5150/5250 Series User’s Manual
Getting Started
2-3
Wiring Requirements
ATTENTION
Safety First!
Be sure to disconnect the power cord before installing and/or wiring your NPort IA5150/5250
Series.
Wiring Caution!
Calculate the maximum possible current in each power wire and common wire. Observe all
electrical codes dictating the maximum current allowable for each wire size.
If the current goes above the maximum ratings, the wiring could overheat, causing serious
damage to your equipment.
Temperature Caution!
Please take care when handling NPort IA5150/5250. When plugged in, NPort IA5150/5250’s
internal components generate heat, and consequently the casing may feel hot to the touch.
You should also heed the following:
y
Use separate paths to route wiring for power and devices. If power wiring and device wiring
paths must cross, make sure the wires are perpendicular at the intersection point.
NOTE: Do not run signal or communication wiring and power wiring in the same wire conduit.
To avoid interference, wires with different signal characteristics should be routed separately.
y
You can use the type of signal transmitted through a wire to determine which wires should be
kept separate. The rule of thumb is that wiring that shares similar electrical characteristics can
be bundled together.
y
Keep input wiring and output wiring separate.
y
Where necessary, it is strongly advised that you label wiring to all devices in the system.
Connecting the Power
Connect the 12-48 VDC power line with NPort IA5150/5250’s terminal block. If the power is
properly supplied, the “Ready” LED will show a solid red color until the system is ready, at which
time the “Ready” LED will change to a green color.
Grounding NPort IA5150/5250 Series
Grounding and wire routing helps limit the effects of noise due to electromagnetic interference
(EMI). Run the ground connection from the ground screw to the grounding surface prior to
connecting devices.
ATTENTION
This product is intended to be mounted to a well-grounded mounting surface such as a metal
panel.