Execute make command – Motorola M68HC08 User Manual
Page 121
User Guide
Application Hardware and Software Configuration
DRM028 — Rev 0
Designer Reference Manual
MOTOROLA
User Guide
121
6.4.3 Software Execution
6.4.3.1 Build
To build the BLDC sensorless with the back-EMF zero crossing
application, open the bldc_zerocross.mcp project file and execute the
Make command, as shown in
. This will build and link the
application and all needed Metrowerks libraries.
Figure 6-5. Execute Make Command
6.4.3.2 Execute from Evaluation Board
To execute the application from MMDS evaluation board
(KITMMDSMR32), choose the Project/Debug command in the Code
Warrior IDE. This will start real-time debugger, load firmware, and
application software to evaluation board MMDS.
The application should then be started from the real-time debugger IDE
by the Run/Start command. For more help with these commands, refer
to the CodeWarrior tutorial documentation located in the CodeWarrior
installation directory.
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
.
..