Getting started, Channel setting (cont’d), Adding/deleting channels – Philips Magnavox MWR20V6 User Manual
Page 20

0
EN
STANDBY-ON
OPEN/CLOSE
VIDEO/TV
VCR
.@/:
GHI
PQRS
TUV
WXYZ
JKL
MNO
ABC
DEF
DVD
DISPLAY
SETUP
OK
0
2
1
4
6
5
3
9
7
8
CHANNEL
TIMER
TIMER SET
SEARCH AUDIO DUBBING
SLOW CM SKIP RAPID PLAY
VCR REC DVD REC REC MODE
DISC MENU
RETURN
CLEAR/C-RESET
TITLE
SPACE
Channel setting (cont’d)
Getting started
4
Select the channel number to
add or delete.
Press
[{] or [CHANNEL
-
] to
move to a lower channel number.
Press
[B] or [CHANNEL
+
] to
move to a higher channel number.
Press
the Number buttons to
select a channel number directly.
5
Using [K / L], select “Add” or
“Delete”. Press [OK].
The channel number will be
added or deleted from the channel
memory. Then the next channel
number will appear so that you
can continue adding or deleting
channels.
6
Press [SETUP] to exit.
Adding/deleting
channels
The channels you no longer
receive or seldom watch can
be deleted from the memory.
You also may add channels into
memory.
1
Press [SETUP].
2
Using [K / L], select “Channel”.
Press [OK].
Channel menu will appear.
3
Using [K / L], select “Manual
Channel Preset”. Press [OK].
Manual Channel Preset menu will
appear.
Manual Channel Preset
CH 2
Add
Delete
VCR DVD
1
2
3
4
5
6
4
Manual Channel Preset
CH 7
Add
Delete
VCR DVD
Note
•
[CHANNEL
-
/
+
] works on
the memorized channel in this
unit.
•
[{ / B] works on all of
channel numbers.
4
Note
• You cannot change the channel when one of the components of the unit (VCR or DVD) is in the recording,
OTR or Timer Recording mode.
• If the auto presetting is cancelled during presetting, some of the channels not yet preset may not be received.
• The selection will depend on how you receive the TV channels.
Press [RETURN] or [SETUP] to cancel the auto presetting during scanning.
To select a channel
You can select a channel by directly entering channel using
the Number buttons on the remote control.
Notes for using the Number buttons:
• When selecting cable channels which are higher than 99, enter channel numbers as a three-digit number.
(For example: 117, press
[1], [1], [7])
• You must precede single-digit channel numbers with a zero (For example: 0, 03, 04 and so on).
• You can select the line input mode (“E1” or “E”). To select “E1” by pressing
[0], [0], [1]. To select “E” by
pressing
[0], [0], [2]. Details are on pages 35-36.
E9A80UD_MWR0V6_01.indd 0
006/01/18 11:45:9