Motorola SB4100 - Manual (Page 13)

For a Single User
1 Connect your computer to the SB4100
using one of the following methods:
Ethernet
Connect the 10/100Base-T shielded Ethernet
cable to the SB4100 Ethernet connector
and the other end to the Ethernet jack
on the back of your computer.
or
USB
Connect the USB cable to the SB4100 port
marked
USB
and the other end to the USB
port on the back of your computer.
2
Connect the coaxial TV cable to the SB4100
connector marked
CABLE
and the other end
to the cable outlet or splitter. Hand-tighten
the connectors to avoid damaging them.
You may need a 5-900 MHz splitter and an
additional length of 75-ohm coaxial cable
if you have a TV connected to the cable
outlet.
3 Plug the power cord into the SB4100
connector marked
POWER
and the other
end to the electrical outlet.
4 For SB4100D, connect the telephone cable to
the SB4100D connector marked with the
phone icon and the other end to the
phone jack.
Introduction Before You Begin Installation Operation Basic Configuration Troubleshooting
To
Ethernet or
USB
To
cable
outlet
To
phone
outlet
To
electrical
outlet
8
Do not connect both Ethernet and
USB cables to the same computer.
CAUTION !
SSUURRFFbbooaarrdd
R
TM