Metrologic Instruments MS9535 - Manual (Page 37)

33
D EFAULT S ETTINGS
Many functions of the scanner and cradle can be “programmed” – that is,
enabled or disabled. The scanner and cradle are shipped from the factory
programmed to a set of default conditions. The default parameter has an
asterisk (*) in the charts on the following pages. If an asterisk is not in the default
column then the default setting is OFF or DISABLED. Every communication
does not support every parameter. If the communication supports a parameter
listed in the charts on the following pages, a check mark will appear.
PARAMETER DEFAULT RS-232
LIGHT
PEN
IBM
46XX
KBW USB
Normal Scan Mode *
Continuous Scan Mode
Blinky Scan
Continuous Blinky Scan
Custom (one shot) Scan
Long-Range In-Stand *
Short-Range In-Stand
Long-Range Out-of-Stand *
Short-Range Out-of-Stand
CodeGate Active In-Stand
CodeGate Inactive In-Stand *
CodeGate Active
Out-of Stand
*
CodeGate Inactive
Out-of Stand
UPC/EAN *
Code 128 *
Code 93 *
Codabar *
Interleaved 2 of 5 (ITF) *
MOD 10 check on ITF
Code 11
Code 39 *
Full ASCII Code 39