Metrologic Instruments MS9535 - Manual (Page 22)

18
V ISUAL I NDICATORS
The MS9535 has three LED indicators (blue, white and amber) located on the
head of the scanner. When the scanner is in operation, the flashing or stationary
activity of the LEDs indicates the status of the current scan and the scanner.
Blue, White & Amber LEDs are off
The scanner receives is not receiving power from the cradle
or the inside battery.
The scanner is in full sleep mode. Pressing the CodeGate
button will wake-up the scanner, and the blue LED will flash.
Steady Amber
After establishing communication, when the scanner is put
into the cradle and the battery has been fully charged, the
amber LED will remain steady.
If the communication is not established, when the scanner is
put into the cradle, the amber LED will stay on after a short
delay.
Steady Blue
When the laser is active, the blue LED is illuminated. The
blue LED will remain illuminated until the laser is
deactivated.
Steady Blue and Single White Flash
When the scanner successfully reads a bar code, the white
LED will flash, the blue LED remains steady and the scanner
will beep once. If the scanner reads the bar code
successfully at a relatively long distance but still within the
10-meter operation range, the white LED may flash after a
short delay.
Steady Blue and Steady White
After a successful scan, the scanner transmits the data to
the cradle. If the cradle is not ready to accept the
information, the scanner’s white LED will remain on until the
data can be transmitted or until a communication time-out
occurs.