Metrologic Instruments MS9535 - Manual (Page 10)

6
K EY B OARD W EDGE S CANNER I NSTALLATION
1. Turn off the host system.
2. Connect the 10-pin RJ45 male connector into the 10-pin modular jack on the
bottom of the cradle. You will hear a ‘click’ when the connection is made.
3. Connect the plug of the power supply into the power jack on the bottom of
the cradle.
4. Connect the power supply into an AC outlet. The blue LED on the rear of the
cradle will stay on.
5. Disconnect the keyboard from the PC.
6. The keyboard wedge cable is terminated with a 5-pin DIN female connector
on one end, and a 6-pin mini DIN male on the other. Metrologic will supply
an adapter cable with a 5-pin DIN male connector on one end and a 6-pin
mini DIN female connector on the other. According to the termination
required, connect the appropriate end of the adapter cable to the main cable,
leaving the necessary termination exposed for connecting to the keyboard
and the keyboard port on the PC.
7. Connect to the main cable to the keyboard and the keyboard port on the host
system.
8. Power up the host system.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (
Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the
power source should meet applicable performance requirements for a limited power source.
&
Optional