beautypg.com

Chapter 3 - easy installation – Macsense Connectivity XRouter Pro User Manual

Page 11

background image

To connect an existing LAN to the XRouter Pro:

As an alternative to connecting computers directly into the XRouter Pro’s
LAN ports, you can also connect a pre-existing network of the computer to
the XRouter Pro by uplinking your network’s central LAN hub to the
XRouter Pro’s uplink port. (See Figure 3.1-3)

To connect a LAN hub to the XRouter Pro’s uplink port:

1. Set the DIP switch (located on the XRouter Pro’s rear panel just

left of the No. 4 LAN port) from “straight” to “crossover” mode.
(See Figure 3.1-2)

2. Plug one RJ-45 connector (of a standard twisted-pair Ethernet

cable) to the XRouter Pro’s No. 4 LAN port.

3. Plug the other end of this Ethernet cable into an available port on

the network hub.

NOTE: Multiple network hubs can be connected to the XRouter Pro’s LAN
ports No.1-3 if these hubs are equipped with uplink ports. By daisy-chaining
a series of hubs, you can connect up to 252 users to the XRouter Pro.

Figure 3.1-3

6

Chapter 3 - EASY INSTALLATION