Marantz SC-7S2 - Manual (Page 9)

ENGLISH
5
Connection 1–4 are recommended by Marantz for SC-7S2 with Marantz MA-9S2.
If using the MA-9S2s, Please read the instruction manual for the MA-9S2.
Name and Function
➔ P13
CONNECTIONS
Standard set-up in using Marantz Monaural Power Amp MA-
9S2.
Please refer to this connection in event of using other Power
Amps also.
• SC-7S2 doesn't have Phono equalizer. So in the event of
using a turn table, please use a Phono equalizer to connect
with the SC-7S2.
• In event that stereo L ch signal has been wired with A ch
input, the signal will come out of the pre-out of A ch. Please
pay attention to L ch, R ch if SC-7S2 is connected with the
other equipment.
BALANCED TERMINAL
q The balanced output connector uses a XLR connector.
w The XLR connector is internally wired in either of the
following two systems.
1. USA system (Pin 2 = COLD, Pin 3 = HOT)
2. European system (Pin 2 = HOT, Pin 3 = COLD)
e The SC-7S2 uses the USA system of 1.
When a preamp or main amplifier adopting the European
system is connected using a cable with XLR balanced
connectors, the reproduced signal may be inverted of
phase.
In this case, correct the wiring of the one of the XLR
connectors on the extremities of the cable to the USA
system by exchanging the connections of pins 2 and 3.
This will make it possible to play the signal with the correct
phase.
06.8.9, 1:52 PM Page 5