Marantz SC-7S2 - Manual (Page 20)

ENGLISH
16
L
TRIM
VOLUME
PHONO CD BALANCED
RECORDER 1 LINE 1
RECORDER 2 LINE 2
EXIT TONE
ENTER
DISPLAY ATT
+
-
R
w
e t
BALANCED BALANCED
CD
LINE 1
DISPLAY DISPLAY ATT LINE 2
RECORDER RECORDER
A SYNC B
i n p u t s e l e c t o r
p o w e r o n / o f f
s t e r e o c o n t r o l a m p l i f i e r s c - 7 s 2
v o l u m e v o l u m e
q y e t w
L
TRIM
CLOSE MODE
PHONO CD BALANCED
RECORDER 1 LINE 1
RECORDER 2 LINE 2
EXIT TONE
ENTER
+
OPEN/ SOUND
R
w
BALANCED BALANCED
CD
LINE 1
DISPLAY DISPLAY ATT LINE 2
RECORDER RECORDER
A SYNC B
i n p u t s e l e c t o r
p o w e r o n / o f f
s t e r e o c o n t r o l a m p l i f i e r s c - 7 s 2
v o l u m e v o l u m e
q w
STANDARD OPERATION
HOW TO PLAY
q Power on the SC-7S2. In case you have several SC-
7S2s connected, please power on from the smaller No. of
ID to the larger No.
Once the power is on, the Front display and input indicator
for the currently selected source will be illuminated.
A SYNC B
BALANCED
CD
LINE 1
LINE 2
RECORDER
POWER
Indicator Input Source
Indicator
Upon initial turn on, the sound will be muted, for
approximately 8 seconds.
w Select the input source by the input selector button or the
Input select button on the Remote control.
e It is recommended to turn the volume down to the minimum
level after each use, before Powering the unit off.
r Play music by operating equipments such as CD Players.
t Adjust the volume by the buttons ▲ / ▼ of SC-7S2 or the
remote controller.
y If the display button is pressed, the volume indicator will
be turned off.
HOW TO RECORD
q Power on SC-7S2.
w Select the source you want to record via the Input selector
on the SC-7S2, or the remote controller. Prepare for
Playback of the selected source. Make sure your recording
unit, is connected to the REC output terminal. Perform
operations on your recording device to begin recording. If
(RECORDER) is selected, for your input source, you will
not be able to record, Because there is no analog output
to the REC out.
06.8.9, 1:53 PM Page 16