Multi-Tech Systems ACCESS POINT RF802EW User Manual

Page 6

RouteFinder Quick Start Guide

2. Connect the Ethernet port of a PC or network device to the LAN port. If you are using

the Uplink option, port number 1 cannot be used as a LAN port.

3. If you are using an analog modem, connect it to the Serial Async port.

4. To use the Uplink option to connect to another network segment, slide the Uplink/

Normal

switch into the Uplink position. Connect the LAN cable to LAN port number 1.

Plug the other end of the LAN cable into another hub, router or switch.

Note: If you are not using the Uplink feature, place the switch in the

Normal position.

5. Connect a network cable from the DSL or Cable modem to the WAN port.

6. Connect the provided power supply cable to the 5VDC power port on the back of the

router. Plug the power supply into an AC power outlet as shown.

7. Power on your DSL modem or Cable.

8. If you are using an analog modem or ISDN TA, power on the device.

9. You are ready to configure software for your router and network PCs.