Motorola RDM2020 User Manual

Page 34

GET

G S

ART

English

Whenever the radio is set up in “Scan Mode”
the LED will signal a fast red blink.
If there is transmission in another channel
during this time, the radio will stay on the active
channel and the transmission on the other
channel will not be heard.
When the transmission is over in the active
channel, the radio will wait for 5 seconds before
resuming Scan again.

To scan a channel without Interference

Eliminator Codes (CTCSS/DPL), set the code
for the channels to ‘0’ in the CTCSS/DPL
Advanced Configuration Mode.

Note:

If Auto-Scan has been enabled for a
particular channel, there is no need to press
the SB2 to start scanning, as the radio will
do it automatically.

SIGNAL STRENGTH AND CHANNEL BUSY
INDICATORS (RDM2080d MODEL)
While receiving, the radio displays the strength
indicator icon

and the LED blinks faster.

The signal strength icon can change from one
bar (weakest) to six bars (strongest) depending
on the radio reception coverage. This can help
determine when a radio is moving out of range.

Note:

Obstacles that block the signal path may
affect the strength of the incoming signal.

This manual is related to the following products:

RDM2080D