Mocomtech SLM-5650 - Manual (Page 155)

SLM-5650 Satellite Modem Revision 1
Remote Control MN/SLM5650.IOM
B–33
Automatic Uplink Power Control (AUPC) Remote Control Commands.
The following commands are only valid when the SLM-5650 modem type has been set to AUPC. Note: Always wait 3 seconds between
consecutive remote modem command/query polls. If Local AUPC is not enabled, query commands will return the last known condition. A
request for status from the remote modem will then be transmitted, ensuring that the next query will return current status.
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
AUPC Local
Enable LPC= 1 byte, value
of 0 or 1 Command or Query.
Local AUPC Control, where:
0=Off
1=On
NOTE: When Local AUPC Control is enabled, modulator output
power is automatically controlled by the modem. Power
output commands via TPL are not allowed during this
mode; although, queries will function as normal.
Example: LPC=1 (Turn on Local AUPC Control)
LPC=
LPC?
LPC*
LPC# LPC? LPC=x
(see description of
arguments)
AUPC
Nominal
Power Level ANP= 5 bytes Command or Query.
Nominal Tx Output power level, where:
s=sign ( + / - )
xx.x = Tx Output power level, +10.0 and –40.0 dBm.
Example: ANP=-13.4 ANP=
ANP?
ANP*
ANP# ANP? ANP=sxx.x
(see description of
arguments)
AUPC
Maximum
Power Level AMX= 5 bytes Command or Query.
Maximum Tx Output power level, where:
s=sign ( + / - )
xx.x = Tx Output power level, +10.0 and –40.0 dBm.
Example: AMX=-13.4 AMX=
AMX?
AMX*
AMX# AMX? AMX=sxx.x
(see description of
arguments)