MicroBoards Technology QD-DVD 127 - Manual (Page 8)

8
Functions
There are 9 different functions for the QD-DVD MultiDrive duplicator: Copy, Test, Test & Copy,
Verify, Compare, Prescan, Disc Info, Edit Track and Setup. For the Setup options, please refer
to pages 14-16.
These instructions refer to using 7 DVD recorder drives (available only in the QD-DVD 127), but
the QD-DVD MultiDrive will operate using any number of the available recorder drives.
Copy
The Copy function is used to copy your master disc to the blank media. The QD-DVD MultiDrive
duplicator will be in Copy mode when it is turned on. The display will read:
Place your master disc into the DVD reader drive (top).
Place your blank media into the DVD recorder drives.
Press the ENT button on the controller interface.
The data will now be copied to the blank discs.
When the job is completed, the recorded discs will be ejected from the recorder drives.
The display will read:
NOTE: CD masters must be copied to CD media, and DVD masters must be copied to DVD
media.
Test
The Test function is used to simulate copying your master disc to the blank media. To use the
Test function, press the ▼ button on the controller until Test is displayed:
In Test mode, the blank media will remain blank and can be used again.
Place your master disc into the DVD reader drive (top).
Place your blank media into the DVD recorder drives.
Press the ENT button on the controller interface.
The duplicator will now simulate writing to the blank discs.
When the job is completed, the recordable discs will be ejected from the recorder drives.
The display will read:
1. Copy
Copying – 16x 48%
2.3GB 03:15
2. Test
Testing – 16x 48%
2.3GB 03:15
1.0 Copy
OK: 07
2.0 Test
OK: 07