MITSUBISHI ELECTRIC WD-73C11 - Manual (Page 5)

5
For assistance call 1(800) 332-2119
Basic Setup and Operation 1
Installing the R emote Control
Batteries
1. Remove the remote control’s back cover by
gently pressing in the tab and lifting off the cover.
2. Load the batteries, making sure the polarities
(+) and (-) are correct. For best results, insert
the negative (-) end first.
3. Snap the cover back in place.
2
1 The remote
control
requires two
AA batteries.
Package Contents
Please take a moment to review the following list of
items to ensure that you have received everything.
TV Overview
Remote
Control
AA
AA
Two AA
Batteries
Basic
Owner’s
Guide
Quick
Setup
Guide
Product
Registration
Card
Before You Begin
1. Review the important safety, installation, and oper-
ating information at the beginning of this book.
2. Choose a location for your TV.
• See the stand requirements on page 2 .
• Allow at least four inches of space on all sides
of the TV to help prevent overheating. Over-
heating may cause premature failure of the TV.
• Avoid locations where light may reflect off the
screen.
3. Install the batteries in the remote control.
4. Plug the TV into an AC power outlet.
TV Control Panel
Buttons on the control panel duplicate some keys on
the remote control.
To display the main menu, press INPUT and VOL+ simul-
taneously for about 10 seconds. Press and hold INPUT
and VOL+ for 10 seconds to clear the menu.
System Reset
If the TV fails to respond to the remote control, the
control-panel buttons, or will not power on/off, perform
System Reset. Press and hold the POWER button on the
control panel for ten seconds.
Sample TV controls and
location of the STATUS
indicator. See page 31 .
Rear Connection
Jacks
Lamp-Compartment
Door