Maytag 110 - Manual (Page 29)

29
INSTALLATION
Check the appliance is electrically safe and gas sound when you have fi nished.
Conversion to LP gas
Check in the Technical Data
section at the back of the book
that the cooker is convertible to
the gas you want to use.
This conversion must be performed by a
competent person. After conversion the
installation must comply with the relevant
regulations and also the local electricity supply
company requirements. Read the instructions
before converting this appliance.
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and lead
to prosecution.
This instruction must be used in conjunction with the rest
of the appliance instruction, in particular for information
on Standards, cooker positioning, connection hose
suitability etc.
When servicing or replacing gas-carrying components
disconnect from gas before commencing operation and
check appliance is gas sound after completion.
Do not use re-conditioned or unauthorised gas controls.
Disconnect from the electricity supply before commencing
servicing. Before electrical re-connection, check that the
appliance is electrically safe.
Jets
Remove burner caps and heads. Remove old jets. Fit new
jets (see the table for the correct jets). Reassemble in
reverse order.
Tap Bypas screws
Pull off all the control knobs.
Open the oven doors and remove the 2 fi xing screws, one
at each end, underneath the control panel.
Pull off the push fi t control panel end caps at each end
and remove the end fi xing screws under the end cap.
Lift the control panel, pull forward and disconnect the
wiring from the rear.
A tap bypass screw
Remove the tap bypass screw and replace with the
correct screw. See the table for the correct bypass
screws.
Stick on label
Stick the appropriate label on to the data badge to
indicate the gas the appliance is now set for.
Pressure Testing
Connect the appliance to the gas supply. Check the
appliance is gas sound.
The gas pressure can be measured at one of the hotplate
burner jets (NOT a Wok burner). Make sure that the
cooker is not connected to the electricity supply. Lift off
a burner head. Fit the pressure gauge to the jet. Turn on
one of the other burners and light it with a match. Turn on
the control for the hotplate burner to which the pressure
gauge is fi tted. Press in the knob to allow the gas through
and register the pressure on the gauge.
After checking the pressure, turn the taps off and replace
the burner head.
Reassemble burner top, making sure it is reassembled in
the correct way on the burner body.
Check the appliance is gas sound.
Check operation of all the burners.
Check that the appliance is
electrically safe.
Natural Gas 20mb L.P. Gas
Hotplate Injector Screw Injector Screw
Wok burner 3.5kW
internal 80
96 3.5kW (246g/h)
internal 54
57
external 129 external 77
Large Burner 3.0kW 134 54 3.0kW (210g/h) 87 40
Medium Burners 1.7kW 109 39 1.7kW (119g/h) 68 32
Small Burner 1.0kW 75 38 1.0kW (70g/h) 51 28