Maytag 110 - Manual (Page 27)

27
INSTALLATION
Check the appliance is electrically safe and gas sound when you have fi nished.
1. Place the cooker in its intended position and level
the appliance.
2. Draw a pencil line 100mm from the front edge of the
levelling feet.
3. Mark the centre line for the bracket by measuring
550mm from the L.H. side of the cooker.
4. Remove the cooker.
5. Measure back from the pencil line 535mm to locate
the front edge of the bracket. Fix bracket to fl oor.
6. Measure height from fl oor level to engagement edge
in back of cooker. Add 3mm to this dimension and
assemble stability bracket to this height. (i.e. from
fl oor level to underside of top member) and ensure
bracket does not foul oven burner assembly.
Gas Connection
A hose is not supplied by with the cooker. Hoses may be
purchased at most builders’ merchants.
The Gas supply needs to terminate with a down facing
bayonet. The rear cover boxes limit the position of the
supply point.
view from the rear
A position for gas supply connector
B appliance gas inlet
Because the height of the cooker can be adjusted and
each connection is different it is diffi cult to give precise
dimensions. Ideally the house supply bayonet should
be in the shaded area shown in the diagram. Although
a 900mm hose can be used, a 1250mm hose will allow
slightly more fl exibility in the positioning of the bayonet
and make moving the cooker easier. The hose should be
fi tted so that both inlet and outlet connections are vertical
so that the hose hangs downwards.
The connector is located just below the hotplate level at
the rear of the cooker.
For Natural Gas the fl exible hose must be in accordance
with B.S.669.
If in doubt contact, your supplier.
Screw connect the threaded end of the hose into the gas
inlet in the underside of the connector block on the back
of the cooker.
After completing the gas connection, check the cooker is
gas sound with a pressure test.
Pressure testing
The gas pressure can be measured at one of the hotplate
burner jets (NOT a Wok burner). Make sure that the
cooker is not connected to the electricity supply. Lift off
a burner head. Fit the pressure gauge to the jet. Turn on
one of the other burners and light it with a match. Turn on
the control for the hotplate burner to which the pressure
gauge is fi tted. Press in the knob to allow the gas through
and register the pressure on the gauge.
Pressures
Natural Gas LP Gas cookers
20mbar. Butane 29mbar
Propane 37mbar
Reassemble burner top, making sure it is reassembled in
the correct way on the burner body.
Electrical Connection
This appliance must be installed by a qualifi ed electrician
to comply with the relevant Institute of Electrical
Engineers (I.E.E.) regulations and also the local
electricity supply company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note
The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker,
through a suitable cooker control unit incorporating a
double pole switch having a contact separation of at least
3mm in all poles. This cooker must not be connected to
an ordinary domestic power point.