Maytag 110 - Manual (Page 28)

28
INSTALLATION
Check the appliance is electrically safe and gas sound when you have fi nished.
The cable size used should be 6mm2 maximum twin and
earth.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your electrical
supply type (see fi g.). Check that the links are correctly
fi tted and that the terminal screws are tight. Secure the
mains cable using the cable clamp.
These appliances are of type X with regard to protection
against over heating of the surrounding surfaces.
Current Operated Earth Leakage Breakers
Where the installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances may
occasionally cause nuisance tripping. In these instances
the cooker circuit may need to be protected by fi tting
100mA device. This work should be carried out by a
qualifi ed electrician.
Hotplate
Check each burner in turn. There is a fl ame safety device
that stops the fl ow of gas to the burner if the fl ame goes
out. There is also a spark ignition system that works when
the knob is pressed in.
For each burner, push in and turn the knob to the solid
fl ame symbol ( ).
The igniter should spark and light the gas. Keep holding
the knob pressed in to let the gas through to the burner
for few seconds. If, when you let go of the control knob,
the burner goes out, the safety device has not held in.
Turn the control to the off position and wait one minute,
then try again this time holding in the control knob for
slightly longer.
Turn off the burners.
Oven check
Set the clock to the time of day
When the clock is fi rst connected the display will fl ash (
) and ( ) alternately.
To set the clock to read the time of day turn and hold the
Timer knob to the clock symbol
and at the same time
turn the Adjusting knob left or right until the clock shows
the time of day. Remember this is a 24 hour clock. Let go
of the Timer knob and it will spring back to the vertical
oven manual setting.
Turn on the oven and check that the oven fan starts to
turn and that the oven starts to heat up.
Check that the oven light is working.
NB. The oven light bulb is not included in the guarantee.
Turn off the oven.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw.
Twist and fi t each end keyhole over their respective
screws. Tighten the fi xing screws.
Customer care
Please complete your contact details in the front of this
section. Please inform the user how to operate the cooker
and hand over the instruction pack.
Thank you.