MITSUBISHI ELECTRIC DLP XD460U - Manual (Page 20)

EN-20
To stop projecting:
8. Press the POWER button.
• A confi rmation message is displayed.
• To cancel the procedure, leave the projector for a while or press the MENU button.
9. Press the POWER button.
• The lamp goes out and the projector goes into a standby mode. In this standby mode, the POWER indicator
blinks red.
10. Wait about one minute for the POWER indicator to be lit in red steadily.
• During this period of one minute in the standby mode, the intake fan and exhaust fan rotate to cool the lamp.
• The lamp can't be lit again for one minute after turned off for safety purpose. It will take another one minute for
the STATUS indicator to go out. If you want to turn on the projector again, wait until the indicator goes out, and
then press the POWER button.
• The air outlet fans rotate faster as the temperature around the projector rises.
• Do not unplug the power cord while the POWER indicator is blinking. Unplugging the power cord immediately
after use may cause a breakdown.
• Though the fan makes loud sounds during cooling, such symptom is not a malfunction.
11. Unplug the power cord from the outlet.
• The POWER indicator will go out.
• If the power cord should be unplugged accidentally while either the air inlet fan or the air outlet fans are oper-
ating or the lamp is on, allow the projector to cool down for 10 minutes with the power off. To light the lamp
again, press the POWER button. If the lamp doesn't light up immediately, repeat pressing the POWER button
two or three times. If it should still fail to light up, replace the lamp.
• Cover the lens with the lens cap to protect it from dust.
POWER STATUS
KEYSTONE
AUTO POSITION
VIDEO COMPUTER
ENTER
MENU
VOLUME
POWER button
POWER button
Viewing video images (continued)
VOLUME 10
Volume from the speaker
Press the VOLUME + or
- button to change the volume from the speaker.
The volume control bar will appear on the screen.
• The volume control bar will disappear about 10 seconds after the VOLUME button is released.
• The VOLUME buttons don
't function while the menu selection bar or the menu is being displayed.
• When a high-level audio signal, such as a DVD audio signal, is supplied to the AUDIO IN terminal, the output from
the speaker may be distorted.