Moxa Technologies 5400 - Manual (Page 11)

Getting Started
Connecting the Hardware
This section describes how to connect NPort 5400 to serial devices for first time testing purposes. We
cover Wiring Requirements, Connecting the Power, Grounding NPort 5400, Connecting to the
Network, and Connecting to a Serial Device.
Wiring Requirements
Safety First!
Be sure to disconnect the power cord before installing and/or wiring your NPort 5400.
Wiring Caution!
Calculate the maximum possible current in each power wire and common wire. Observe all electrical
codes dictating the maximum current allowable for each wire size.
If the current goes above the maximum ratings, the wiring could overheat, causing serious damage to
your equipment.
Temperature Caution!
Please take care when handling NPort 5400. When plugged in, NPort 5420/5430/5430I’s internal
components generate heat, and consequently the casing may feel hot to the touch.
You should also pay attention to the following points:
Use separate paths to route wiring for power and devices. If power wiring and device wiring paths
must cross, make sure the wires are perpendicular at the intersection point.
NOTE: Do not run signal or communication wiring and power wiring in the same wire conduit.
To avoid interference, wires with different signal characteristics should be routed separately.
You can use the type of signal transmitted through a wire to determine which wires should be
kept separate. The rule of thumb is that wiring that shares similar electrical characteristics can be
bundled together.
Keep input wiring and output wiring separate.
Where necessary, it is strongly advised that you label wiring to all devices in the system.
Connecting the Power
Connect the 12-48 VDC power line with NPort 5400’s terminal block. If the power is properly
supplied, the “Ready” LED will show a solid red color until the system is ready, at which time the
“Ready” LED will change to a green color.
NPort 5400 Series User’s Manual 2-3