MITSUBISHI ELECTRIC Mitsubishi Home Refrigerator MR-G50J-SS-NZ - Manual (Page 38)

38
OPERATING PROCEDURE PHOTOS
6. Operation panel
(1)Slide the operation panel in the direction of the arrows, unit it
stops. (See figure 3.)
(2)Pull out the operation panel as shown in a figure 4.
(See figure 4.)
1 Please pull it out carefully because it is still wired to the body.
(3)Take out the panel by detaching the connector of lead wires from
the body.
(See figure 5.)
1 If the horizontal slide is hard to remove with hands, put plate
on the right edge of the panel (please put protective object such
as tapes on the area of contact on the door panel and the opera-
tion panel), and gently tap it in the sliding direction.
(See figure 3.)
Note :
How to remove
7. Rotational heater board
(1)Remove four fixing screws to remove the rotational heater
board. (See photo 14)
(2)Remove a screw on the wiring cover and disconnect the
connector in the cover. (See photo 14)
Caution on assembly
When raising the rotational heater board, replace the rotational
heater board as it was. if the refrigerator door is closed with the
board raised, the rotational heater board may hit against the
left door of refrigerator and be damaged.
Though heater preventing dewdrop may make rotational heater
board hot, it does not affect food inside.
Refer to right figure when installing the rotational heater board.
(See figure 6)
● Loosen the fixing screw and adjust a vertical (upper and lower)
motion.
● After assembling, make sure that the rotational heater board fits
the guide properly and works properly.
Figure 6
Photo 14
Screws
Wiring cover
Rotational
heater board
Screws
Guide
(4)mm
3 i 2mm
(715)
Rotational heater
board
Left door of
refrigerator
compartment
Note :
Connector
Operation
panel
Figure 3
Figure 4
Figure 5
OA090-2.qxp 06.7.20 9:57 AM Page 38