beautypg.com

MITSUBISHI ELECTRIC Mitsubishi Home Refrigerator MR-G50J-SS-NZ User Manual

Page 11

background image

11

2

2

Display

After the setting is complete, the kinds of thermistor and its temperature are alternately shown on the panel.

In case of abnormality, the display returns to current temperature. Please note that the temperature detected
by thermistor may be a little different from the real one due to the influence of refrigerator temperature.

3

3

Change of display

While thermistor temperature check mode is set, press . A short beep sound is heard at each press

and the thermistor is changed in the order below.

Defrosting Refrigerator compartment Slide chilled compartment

Ice making compartment Versa compartment Ice making tray
Vegetable compartment Freezer compartment Outside air

W

The defrosting thermistor is always selected first at the beginning of the setting.

4

4

Release

With the door of ice making compartment left open, simultaneously press and
for about 3 seconds until a beep sound is heard. The temperature of thermistor disappears
and the display gets back to current temperature.

The function is automatically released one-hour later.

Follow the procedure above to release this mode. For the prevention of the compressor, avoid releasing

it by plugging and unplugging the power cord.

(6) Change mode of compressor rotational speed

Operation sound can be checked by changing the rotational speed of compressor. Always conduct a check while the

compressor is operating and the “-” mark is not on the display, which shows the compressor stops. If the “-” mark is on the
display, unplug the power cord and then plug it in a few seconds to operate the compressor. Also, this function is not
available during the following modes: Child lock, Demonstration, Cooking timer, Thermistor temperature check and error
code display.

1

1

Setting

With the door of ice making compartment left open, simultaneously press and
for about 3 seconds until a “beep” sound is heard, and “

88

” blinks.

Press with the door left open.

2

2

Changing the rotational speed

After the setting is complete, press and the rotational speed of compressor alternately changes in 6 steps.

The rotational speed (rps) is shown on the panel. Basically the compressor starts operating at level 5, however, it depends
on model or specification change.

W

Note: Operation sound may get increased in the process of changing the speed, but that does not mean any

problem. Check the operation sound when the rotation is stabilized.

3

3

ON and OFF of machine chamber fan motor

Under this function, fan motor in machine chamber can be switched on and off at each press of switch.
The on/off state is shown with mark on the panel.

4

4

Release

With the door of ice making compartment left open, simultaneously press and for about 3 seconds until a
“beep” sound is heard. The screen returns to the temperature display.

The function is automatically released one-hour later.

Follow the procedure above to release this function. For the prevention of the compressor, avoid releasing it by plugging
and unplugging the power cord.

Machine chamber fan motor

ON

OFF

Display of

Displayed

Not displayed

(Ex.) When defrost

thermistor
reads -28

:

.

Kind of

thermistor

Defrosting

Refrigerator

compartment

Slide chilled

compartment

Versa

compartment

Ice making

compartment

Ice making

tray

Vegetable

compartment

Freezer

compartment

Outside air

Display

(d)

(R)

(C)

(K)

(S)

(I)

(V)

(F)

(O)

Level 0

Level 1

Level 2

Level 3

Level 4

Level 5

Normal

Low speed

High speed

d

-

28

TEMP

TEMP

52

TEMP

(Ex.) When the rotational

speed is 52 rps

OA090-1.qxp 06.7.20 9:54 AM Page 11