MITSUBISHI ELECTRIC Mitsubishi Home Refrigerator MR-G50J-SS-NZ - Manual (Page 37)

37
OPERATING PROCEDURE PHOTOS
4. Parts inside the refrigerator compartment ➔ Left rail of the
slide compartment ➔ Parts inside the ice making compart-
ment ➔ Ice making compartment door ➔ Tank holder ➔
Door switch
(1)Remove the parts inside the refrigerator compartment.
(See procedure [2])
(2)Remove the left rail of the slide compartment.
(See procedure [2])
(3)Remove the parts inside the ice making compartment.
(See procedure [3])
(4)Remove the ice making compartment door.
(5)Remove a screw on the side of the refrigerator compartment.
(6)Remove label and screw
A (two screws). Pull the tank window.
(7)Loosen screw A (three screws) halfway on the side of the ice
making compartment. Put a screwdriver on the head of each
screw and top the bottom side of the holder softly to detach it.
(See photo 12)
(8)Lift up the tank holder from the refrigerator compartment to
remove it.
Note:
1 Put the lead wires in place so that they do not get caught in
water supply channel.
2 Put the tank holder in place so that the water does not leak from
it.
(9)Insert a minus screwdriver between switch and body to remove
the door switch.
5. Parts inside the versa compartment ➔ Ceiling of versa
compartment
(1)Take out interior parts of versa compartment.
(2)Lift up and pull out the versa-compartment door.
(3)To detach the ceiling, remove rivet F (three rivets) and pull
down the ceiling.
(See photo 13)
1 Be sure that all the parts are fitted securely in place.
Caution on assembly
Ceiling of versa compartment
Door switch
Tank holder
Door switch
Photo 13
Ceiling of versa compartment
Screw A
Tank holder
Rivet F
Rivet F
Rivet F
Photo 12
Figure 2
Tank holder
Label
Tank window
OA090-2.qxp 06.7.20 9:57 AM Page 37