Miller Electric and DS-74DX16 - Manual (Page 24)

OM-1500-14 Page 20
SECTION 5 − OPERATION
5-1. Operational Terms
The following is a list of terms and their definitions as they apply to this wire feeder:
General Terms:
Cold Wire Jog Feeding wire without contactor or gas valve being energized.
Sequence A portion of the weld program, such as preflow, run-in, start, weld, crater, burnback, and postflow.
Weld Program A group of sequences that make up a weld cycle.
5-2. Power Switch
1 Power Switch
1
803 193
1 Left/Right Select Switch
Pressing the Left/Right Select
switch allows the operator to
choose which side of the units’ con-
trols will operate.
5-3. Left/Right Select Switch
1
803 194
.
Engaging the Left or Right
Gun Trigger also allows the
operator to enable the con-
trols on that side of the unit.