Miller Electric and DS-74DX16 - Manual (Page 16)

OM-1500-14 Page 12
4-2. Installing Control Box And Adjusting Tilt
1 Weld Control
2 Bracket
3 Screw
Bracket and screws are installed
onto bottom of control at factory.
4
Swivel
Loosen screws. Place control on
swivel and slide forward. Tighten
screws.
5
Tilt Bracket
6 Rear Pivot Screw
7 Front Screw
Loosen rear pivot screw. Remove
front screw. Pivot control down-
ward to desired viewing angle. Re-
place and tighten front screw. Tight-
en pivot screw.
803 192
Tools Needed:
1
2
3
4
3/8 in
5
6
7
4-3. Installing Boom And Reel Support
ST-153 170-A
1 Swivel Plates
2 Yoke
Remove hardware from swivel
plates and yoke.
3
Boom
Set boom into swivel as shown.
4
Yoke Pin
Install pin through yoke. Install cot-
ter pin and spread ends.
5
Bolt
Install bolt, washers, and nut. Tight-
en hardware, and back bolt off one
half turn.
6
Locking Knob
Install locking knob but do not
tighten.
7
Reel Support
Install reel support.
Tools Needed:
3/8, 3/4 in
3
4
5
6
7
1
2