Multiquip MQ Power 3-Position Switch/Paralleling 1400 Amp Studio Generator SG1400C3 - Manual (Page 27)

Sg1400C3 STudio generaTor • operaTion manual — rev. #0 (10/05/11) — page 27
DiGitaL COntrOLLEr
Refer to Figure 9 for location of controls and indicators.
1.
STaTuS led — Indicates status of the controller.
Lights green when the controller is running.
navigaTionS BuTTonS
2. arroW up Button — Press button to scroll up
through the status menus or programming prompts.
3. arroW doWn Button — Press button to scroll down
through the status menus or programming prompts.
4. menu Button — Press button to jump to menu/sub-
menu page or escape from any dialog window.
5. enTer Button — Press button to confirm a value or
open a value adjustment within setting dialogs.
ConTeXT BuTTonS
6. mode Button — Press button to jump to the controller
mode window.
7. HiSTorY Button — Press button to jump to history
screen.
8. alarm Button — Press button to jump to alarm list
9. gCB (generator Circuit Breaker) ConTrol
Button — Press button to close/open GCB.
10. mCB ConTrol Button — Not functional in this
application.
ConTrol BuTTonS
11. STarT Button — Press button to go idle mode (about
an hour) then generator starts. A second press will
bypass idle mode and generator goes to full speed
immediately.
12. STop Button — Press button to cool the generator
for about 5 minutes then the generator will stop. A
second press will bypass cool down and will stop the
generator immediately.
13. FaulT reSeT Button — Press button to acknowledge
faults and alarms (active only in Alarm screen).
14. Horn reSeT Button — Press button to deactivate
the horn (audible alarm).
15. diSplaY — Shows menu, measurements, setpoints,
alarm list, history, and help/others screens.
NOTICE
STarT and STop buttons work in MAN (manual) or
SEM (semi-manual) mode only.
NOTICE
For more detailed operating and programming
information on the digital controller, refer to the
InteliVision 5™ Controller User's Guide.
Figure 9. Digital Controller
1
4
5
2
3
6 7
11
14
13
12
15
10 9 8