beautypg.com

Multi-Tech Systems MT3334ZDX User Manual

Page 31

background image

3 - AT Commands, S-Registers and Result Codes

31

Command:

X

n

Result Code Selection

Values:

n = 0–4

Default:

4

Description: X0

Basic Result Codes (

e.g., CONNECT); does not

look for dial tone or busy signal.

X1

Extended Result Codes (

CONNECT 33600 V42bis,

etc.); does not look for dial tone or busy signal.

X2

Extended Result Codes with

NO DIALTONE; does

not look for busy signal.

X3

Extended Result Codes with

BUSY; does not look

for dial tone.

X4

Extended Result Codes with

NO DIALTONE and

BUSY.

Command:

Y

n

Long Space Disconnect

Values:

n = 0

Default:

0

Description: Y0

Disable sending or responding to long space break
signal on disconnect.

Y1

Enable sending or responding to long space break
signal on disconnect. (Not supported.)

Command:

Z

n

Modem Reset

Values:

n = 0 or 1

Default:

None

Description: Z0

Reset modem to profile saved by the last

&W

command.

Z1

Same as Z0.

Command:

&C

n

Data Carrier Detect (DCD) Control

Values:

n = 0 or 1

Default:

1

Description: &C0

Ignores the state of carrier on the remote modem

and DCD circuit is always on.

&C1

DCD turns on when the remote modem’s carrier
signal is detected and DCD is off when the carrier
signal is not detected.

This manual is related to the following products: