Installing the handsfree kit, Guidelines for installation and connection, How to install the handsfree kit – Motorola 6840420Z01-AD User Manual
Page 6
9
Installing the Handsfree
Kit
Installing the
Handsfree Kit
Guidelines for Installation and
Connection
• Only qualified personnel should install this car kit. If
necessary, contact the vehicle manufacturer for air
bag information specific to the vehicle.
Caution: An air bag inflates with great force. DO NOT
place objects, including communication equipment, in the
area over the air bag or in the air bag deployment area. If
the communication equipment is improperly installed and
the air bag inflates, serious injury could occur.
• Mount components securely on strong surfaces to
prevent shifting that could cause injury or interfere
with safe vehicle operation. Always use the supplied
mounting hardware
• Mounted components and attached wires or cables
must not interfere with seating or leg space.
• Route cables so they are protected from pinching,
sharp edges, and crushing. Keep all in-line
connectors easily accessible.
• This car kit is intended for use in 12 volt negative
ground systems only. The car kit draws less than 5
amps. Confirm that the vehicle’s electrical system can
supply this current.
10
Installing the Handsfree
Kit
How to Install the Handsfree
Kit
Caution: This car kit must be connected to a 5A fuse in
the car fuse panel to prevent fire or other damages if a
short circuit should occur somewhere in the electronic
module. Before installing the car kit, disconnect the
vehicle’s battery.
Before you begin: Unpack, assemble, and test all
components on a service bench.
Car Kit Contents
Interface Cable
The Interface Cable connects the electronic module to the
other system components. It connects the vehicle’s power
and ignition to the car kit and provides some optional audio
connections when the car kit is used with the vehicle’s
radio.
Electronic Module
You can place the electronic module anywhere inside the
vehicle to facilitate convenient connection between the
interface cable and other system components.
Microphone
The microphone cable can be routed along the side of the
vehicle, through the dash, and along the edge of the
windshield. The microphone is placed best near the
rearview mirror and aimed directly toward the user.