Multi-Tech Systems MTASR3-200 - Manual (Page 66)

RASFinder User Guide
MTASR3-200 66
Command: \G n Modem Port Flow Control
Values: n = 0
Default: 0
Description: \G0 Returns an OK for backward compatibility with some software.
\G1 Not supported—responds ERROR.
Command: \J n Data Buffer Control
Values: n = 0
Default: 0
Description: \J0 Enable data buffer—serial port speed is independent of connect speed.
\J1 Not supported—responds ERROR.
Command: \K n Set Break Control
Values: n = 5
Default: 5
Description: \K5 Modem sends break signal received from the DTE to the remote modem.
Command: \N n Error Correction Mode Selection
Values: n = 0–5, or 7
Default: 3
Description: \N0 Non-error correction mode with data buffering (same as &Q6).
\N1 Direct mode.
\N2 MNP reliable mode.
\N3 V.42/MNP auto-reliable mode.
\N4 V.42 reliable mode.
\N5 V.42, MNP, or non-error correction (same as \N3).
\N7 V.42, MNP, or non-error correction (same as \N3).
Command: \Q n Local Flow Control Selection
Values: n = 0, 1, or 3
Default: 3
Description: \Q0 Disable flow control (same as &K0).
\Q1 XON/XOFF software flow control (same as &K4).
\Q2 CTS-only flow control. Not supported—responds ERROR.
\Q3 RTS/CTS hardware flow control (same as &K3).
Command: \T n Inactivity Timer
Values: n = 0–255
Default: n/a
Description: \Tn Inactivity timer setting contingent on either \T value or S-Register S30 value (e.g.,
AT\T45&W0 configures in parallel ATS30=45&W0), and vice versa.
Command: \V n Protocol Result Code
Values: n = 0 or 1
Default: 1
Description: \V0 Disable protocol result code appended to DCE speed.
\V1 Enable protocol result code appended to DCE speed.
Command: \X n XON/XOFF Pass-Through
Values: n = 0 or 1
Defaults: 0
Description: \X0 Respond to and discard XON/XOFF characters.
\X1 Not supported—responds ERROR.
Command: -C n Data Calling Tone
Values: n = 0 or 1
Defaults: 0
Description: -C0 Disable V.25 data calling tone.
-C1 Enable V.25 data calling tone.