Multi-Tech Systems MTASR3-200 User Manual
Page 64
RASFinder User Guide
MTASR3-200
64
Command:
X
n
Result Code Selection
Values:
n = 0–7
Default:
4
Description:
X0
Basic result codes (
e.g., CONNECT); does not look for dial tone or busy signal.
X1
Extended result codes (
CONNECT 56000 V42bis, CONNECT 33600 V42bis, etc.); does not look
for dial tone or busy signal.
X2
Extended result codes with
NO DIALTONE; does not look for busy signal.
X3
Extended result codes with
BUSY; does not look for dial tone.
X4
Extended result codes with
NO DIALTONE and BUSY.
X5
Extended result codes with
NO DIALTONE and BUSY.
X6
Extended result codes with
NO DIALTONE and BUSY.
X7
Basic result codes with
NO DIALTONE and BUSY.
Command:
Y
n
Long Space Disconnect
Values:
n = 0
Default:
0
Description:
Y0
Disable sending or responding to long space break signal on disconnect.
Y1
Enable sending or responding to long space break signal on disconnect. (Not supported.)
Command:
Z
n
Modem Reset
Values:
n = 0 or 1
Default:
None
Description:
Z0
Reset modem to profile saved by the last
&W command.
Z1
Same as Z0.
Command:
&B
n
V.32 Auto Retrain
Values:
n = 1
Default:
1
Description:
&B0
Disable V.32 auto retrain. (Not supported.)
&B1
Enable V.32 auto retrain.
Command:
&C
n
Data Carrier Detect (DCD) Control
Values:
n = 0 or 1
Default:
1
Description:
&C0
Force Data Carrier Detect signal high.
&C1
Let Data Carrier Detect follow carrier signal.
Command:
&D
n
Data Terminal Ready (DTR) Control
Values:
n = 0, 1, 2, or 3
Default:
2
Description:
&D0
Modem ignores DTR signal.
&D1
When DTR drops while in online data mode, the modem enters command mode, issues an OK,
and remains connected.
&D2
When DTR drops while in online data mode, the modem hangs up.
&D3
When DTR drops, the modem hangs up and resets as if an ATZ command were issued.
Command:
&F
n
Load Factory Default Settings
Values:
n = 0
Default:
None
Description:
&F0
Load factory settings as active configuration.
Command:
&G
n
V.22bis Guard Tone Control
Values:
n = 0, 1, or 2
Default:
0
Description:
&G0
Disable guard tone.
&G1
Enable 550 Hz guard tone.
&G2
Enable 1800 Hz guard tone.
*
:
The
&G command is not used in North America.