beautypg.com

Automatic transaxle fluid (atf), Automatic transaxle fluid (atf) -26, Form no.8as7-ea-09e – Mazda 2010 CX-7 User Manual

Page 410: Owner maintenance, Caution

background image

Black plate (410,1)

Automatic Transaxle Fluid
(ATF)

qInspecting Automatic Transaxle

Fluid Level

The automatic transaxle fluid level should
be inspected regularly. Measure it as
described below.

5AT

CAUTION

Ø Always check the automatic

transaxle fluid level according to
the following procedure. If the
procedure is not done correctly,
the automatic transaxle fluid level
cannot be measured accurately
which could lead to automatic
transaxle damage.

Ø A low fluid level can cause

transaxle slippage. Overfilling can
cause foaming, loss of fluid, and
transaxle malfunction.

Ø It is recommended to use Mazda

Genuine automatic transaxle fluid
(page 10-4).

1. Park on a level surface and set the

parking brake firmly.

2. Make sure there is no ATF leakage

from the ATF hose or the housing.

3. Shift the shift lever to the park position

(P), start the engine and warm it up.

CAUTION

Do not shift the shift lever while the
engine is warming up. If the ATF level
is extremely low, the automatic
transaxle could be damaged.

4. While the engine is still idling, pull out

the dipstick and wipe it clean, and then
put it back.

5. Check the ATF level. If there is no ATF

adhering 5 mm from the end of the
dipstick, add ATF.

CAUTION

If there is no ATF adhering to the
dipstick even after the engine has
been warmed up, do not drive the
vehicle. Otherwise, the automatic
transaxle could be damaged.

6. Shift the shift lever to each range and

position, and make sure there is no
abnormality.

7. Drive the vehicle on city roads for

5 km (3.1 mile) or more.

8. Park on a level surface and set the

parking brake firmly.

9. Shift the shift lever to the park position

(P), check the ATF level while the
engine is idling, and make sure that the
ATF level is within the proper level. If
the ATF level is not within the proper
level, add ATF.
The proper fluid level is marked on the
dipstick as follows.

Full

OK

Low

8-26

Maintenance and Care

Owner Maintenance

CX-7_8AS7-EA-09E_Edition2 Page410
Friday, June 5 2009 2:26 PM

Form No.8AS7-EA-09E