Marantz SR5400U - Manual (Page 17)

14
ENGLISH
AUDIO
COMPONENT VIDEO
DIGITAL OUT DIGITAL IN
OPT. COAX.
ANTENNA
SURROUND BACK FRONT CENTER SURROUND
L R L R
4 3 1 2
6.1CH
IN
IN OUT
TAPE CDR/MD
OUT SW OUT IN
CD C
SB
SL L
IN OUT IN
R
TV DVD DSS/VCR2
R SR
L
VCR1 OUT
IN RC-5
PRE OUT
SR SW R
L SL C
SB
DVD TV MONI. VIDEO VCR1 OUT OUT IN DSS/VCR2 OUT IN VCR1 DSS/VCR2 DVD IN OUT
S-VIDEO
MONI.OUT TV OUT IN
CB / PB CR / PR CR / PR CR / PR CB / PB CB / PB DVD Y Y MONI.OUT DSS/VCR2 Y
FM (75 Ω ) GND AM AC IN
SERIAL NO.
100W MAX.
AC OUTLETS 230V 50H Z UNSWITCHED
6 - 8 OHMS SPEAKER SYSTEMS
6.1CH
IN
SW
C
SB
SL L
R SR
PRE OUT
SR SW R
L SL C
SB
L
R
FRONT SURR. SURR.
BACK
SUB
WOOFER
CENTER
L
R
FRONT SURR. SURR.
BACK
SUB
WOOFER
CENTER
R L R L
L R
R L
L R
R L
R L R L
ADVANCED CONNECTING
CONNECTING MULTI CHANNEL AUDIO SOURCE
The 6.1CH INPUT jacks are for multichannel audio
source such as a SACD multichannel player, DVD
audio player or external decoder.
If you use these jacks, switch on the 6.1CH INPUT
and set the 6.1CH INPUT level by using the SETUP
MAIN MENU. See page 19.
CONNECTING AN EXTERNAL POWER AMPLIFIER
The PREOUT jacks are for connecting external
power amplifiers.
Be sure to connect each speaker to the corresponding
external power amplifier.
POWER
AMPLIFER
DVD AUDIO PLAYER
or
SACD MULTI CHANNEL PLAYER
Center Front
Left Front
Right
Surround
Left Surround
Right
Subwoofer
Surround Back
AUDIO
COMPONENT VIDEO
DIGITAL OUT DIGITAL IN
OPT. COAX.
ANTENNA
SURROUND BACK FRONT CENTER SURROUND
L R L R
4 3 1 2
6.1CH
IN
IN OUT
TAPE CDR/MD
OUT SW OUT IN
CD C
SB
SL L
IN OUT IN
R
TV DVD DSS/VCR2
R SR
L
VCR1 OUT
IN RC-5
PRE OUT
SR SW R
L SL C
SB
DVD TV MONI. VIDEO VCR1 OUT OUT IN DSS/VCR2 OUT IN VCR1 DSS/VCR2 DVD IN OUT
S-VIDEO
MONI.OUT TV OUT IN
CB/PB CR/PR CR/PR CR/PR CB/PB CB/PB DVD Y Y MONI.OUT DSS/VCR2 Y
FM (75 Ω ) GND AM AC IN
SERIAL NO.
100W MAX.
AC OUTLETS 230V 50HZ UNSWITCHED
6 - 8 OHMS SPEAKER SYSTEMS
OUT
RC-5 IN
REMOTE
CONTROL
REMOTE
CONTROL
REMOTE
CONTROL
IN
OUT
IN
OUT
IN
OUT
EXTERNAL INTERNAL EXTERNAL INTERNAL EXTERNAL INTERNAL
1
RC OUT
2
CONNECTING THE REMOTE CONTROL JACKS
MD DECK CD RECORDER
q
You can control other Marantz products through
this unit with the remote control by connecting the
REMOTE CONTROL terminals on each unit.
The signal transmitted from the remote control is
received by the remote sensor on this unit. Then the
signal is sent to the connected device through this
terminal. Therefore you only need to aim the remote
at one unit. Also, if a Marantz power amplifier (some
models excluded) is connected to one of these
terminals, the power amplifier’s, power switch is
synchronized with this unit’s power switch.
Set the REMOTE CONTROL SWITCH on the units,
other than the main unit to EXT.(EXTERNAL) for
this feature.
CD PLAYER
OPTION
w
Whenever external infrared sensors or similar
devices are connected to RC-5 IN of the SR5400,
be sure to always disable operation of the infrared
sensor on the main unit by using the following
procedure.
1. Hold down the SELECT button and TV button
on the front panel at the same time for five
seconds.
2. The setting “IR=ENABLE” is shown on the FL
DISPLAY.
3. Press the SELECT button to change this to
“IR=DISABLE”.
4. Press the ENTER button. Once this setting is
made, the infrared sensor on the main unit is
disabled.
Note:
Be sure to set to “IR=ENABLE” when external
infrared sensors or similar devices are not
connected. Otherwise, the main unit will be
unable to receive remote control commands.
5. To restore the original setting, perform steps 1
to 4 to set to “IR=ENABLE”.