Mio C710 - Manual (Page 47)

47
4.6.1.3 Built-in cameras
Some cameras are built in traffic lights. They work like fixed cameras, but they are
difficult to spot. The warning for proximity and speeding is the same as for the fixed
cameras.
These cameras are displayed with the following symbol:
4.6.1.4 Section control cameras
These cameras work in pairs, and do not measure your current speed but your
average speed between the two cameras. Both will identify your car, and record the
exact time you pass them. The difference between the two points of time will be used
to calculate your average speed.
MioMap will warn you when you approach one of these cameras, but as you pass
by, the warning stays on, and your average speed is measured until you reach
another camera of this type. If your average speed exceeds the speed limit between
the two cameras, you will receive the same special warning sound as with the other
camera types.
Note: In the rare case MioMap cannot register the moment you pass the second
camera (e.g. it is placed at the exit of a tunnel where GPS position is not yet
available) the warning will continue. Just tap the camera symbol displayed on the left
to stop the warning.
These cameras are displayed with the following symbol:
4.6.2 Controlled traffic direction
The different cameras can measure the speed of one direction of the traffic, both
directions, or even several directions in an intersection, when they are mounted on a
rotating base. MioMap warns you only if you drive in a measured or possibly
measured direction.
The measured direction of the cameras are displayed with the following symbols: