Motorola DVD - Manual (Page 40)

35
I n s t r u c t i o n s : P o w e r , V o l u m e , M u t e , T V I n p u t
4
seconds (until the red light at the end of the remote lights up and stays on when you
release the buttons).
2. Enter the search code. Refer to the table below and use the number keys on your
remote control to enter the appropriate code.
After you press the fourth digit of the code, the red light on the end of the remote
control will flash twice, then remain on.
3. Test the remote control. Point the remote control at the TV or A/V receiver. Press
CHAN UP to test the first code. The test is successful if the TV or A/V receiver
responds (by powering off, changing input, or muting, depending on the function you
are trying to program). If there is no response, wait two or three seconds, then press
CHAN UP again. Continue doing this until the TV or A/V receiver responds.
When the TV or A/V receiver responds, press ENTER to select the current code. The
red light at the end of the remote control will flash three times to indicate that the
remote control is properly coded to control your device.
To Control:
TV power, volume,
mute, and TV
Input TV input only A/V system
power A/V system
volume and
mute
Press the:
TV PWR and TiVo
buttons
TV INPUT and
TiVo buttons
TV PWR and TiVo
buttons
MUTE and TiVo
buttons
To Test:
TV power, volume,
mute, and TV Input TV input only A/V system
power
A/V system
volume and mute
Enter:
0999 0999 1999 1999