Mitel 5055 - Manual (Page 87)

Appendix C — Configuration Files
- 81 -
# the condition defined by the "try_ring_nums"
noans_fwd_mode= 0
# call forwarding no answer after defined number of rings
# integer [1, 20]
try_ring_nums= 4
# call forwarding no answer address
# sip url for forwarding the call
# in the format of user_id, or [email protected]
# if only user_id is configured, the call will be forwarded to the user_id@proxy
noans_fwd_addr= 1002
# call forwarding always mode
# choice [0-disabled, 1- enabled]
# when enabled, the incoming call will be forwarded to the "always_fwd_addr"
always_fwd_mode= 0
# call forwarding always address
# sip url for forwarding the call
# in the format of user_id, or [email protected]
# if only user_id is configured, the call will be forwarded to the user_id@proxy
always_fwd_addr= 1002
# call forwarding when busy mode
# choice [0-disabled, 1- enabled]
# when enabled, the incoming call will be forwarded to the "forward_addr"
busy_fwd_mode= 0
# call forwarding when busy forward address
# sip url for forwarding the call
# in the format of user_id, or [email protected]
# if only user_id is configured, the call will be forwarded to user_id@proxy
busy_fwd_addr= 1002
# beep on hold
# choice [0- disable, 1- enable]
# If enabled, the SIP phone, when being held by the peer party, will generate beeps in
the receiver.
# if the sip proxy or back-2-back UA supports music on hold, this feature should be
disabled
beep_on_hold= 1
# on hold ringback timer
# if the sip phone puts the peer party on hold, and the handset is being put down on the
cradle, the
# sip phone will play a ringback signal after a period defined by this parameter
# to alert the user that there is a call on hold.
on_hold_alert= 300; seconds
# hot line
# choice [0-disable, 1-enable]
# when enabled, whenever the user pickup the phone handset, the call is automatically
# made to the hot_address.
hot_line= 0
# hot line address type
# choice [0-number or id mode, 1-sip url]
hot_addr_type= 1
# hot line address
# defines the address with the format defined by the hot_addr_type
hot_address= [email protected]
#adminId
adminId= admin
#admin password
admin_passwd=be6ad8761fe4eb9bb85934a2d21686bb