Multiquip Concrete Saw SP-6457 TD - Manual (Page 45)

45
CAUTION
§ Over-tensioning shortens belt and bearing life.
§ Keep belts clean of foreign material that may cause slippage.
§ Make V-Belt inspection a periodic procedure.
§ Never dress belts, as this can cause premature failure.
Adjusting Blade Shaft Drive Belt Tension
!
NOTE
When tightening or loosening drive belts, raise the saw to reduce
stress on the tensioning system, and gravity will assist you by pulling
the engine backwards slightly.
1. Access the Panel on the side of the saw, loosen the Engine Mount Lock
Bolts to allow the engine to rotate forward.
• Requires 15/16” socket, 10”- 12” extension and ratchet or breaker bar.
Fig. 27 — Engine Mount Lock Bolts
Engine Mount
Lock Bolt
Engine Mount
Lock Bolt
Access Panel