Multiquip Concrete Saw SP-6457 TD - Manual (Page 34)

34
4. If an air compressor is available, blow out the system by applying
compressed air to the Water Inlet ( see Fig. 10).
Pointer Adjustment
1. Lower the front pointer assembly.
• Adjust the pointer rod (1) by loosening the lock knob (2).
• Once the pointer rod is set to the cut line, tighten the lock knob.
2. Adjust the rear pointer to the cut line:
• Loosen the lock bolt, position the pointer rod, and tighten the lock bolt.
3. To raise the front pointer assembly, pull back and up on the pointer cable (3).
• Secure the pointer assembly in the desired raised position by locking the
cable between the jaws of the cam cleat (5).
Fig. 15 — Pointer Adjustment
1
2
3
4
5
6